What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 03.07.2025 03:34

This device then solves the entire problem.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
10-year Treasury yield eases after May core inflation is less than expected - CNBC
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Upvotes:
Scientists Confirm Anti-Aging Drug Appears to Prolong Life in Animals - ScienceAlert
These are simplified answers to the original question, and does not change anything I wrote above.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
but I think this circuit , shows a few more pieces.
Cholesterol: Daily cup of beans may lower levels, improve heart health - MedicalNewsToday
One is “what exactly is in a ‘surge protector’ ? ”
For this case there are devices called Metal oxide varistors (MOV).
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
The third is lightning and “how it gets conducted into a home.”
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
2024–10–16 [ OO OLAOYE OYEBODE ]
the problem then depends on "how fast does the fuse operate?".
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
What movies have not aged well?
eight
This is where the MOV conducts again, and dissipated the energy.
He then describes Rainy Season and Lightning.
AMD confirms AGESA 1.2.0.3e fixes TPM security flaw - VideoCardz.com
It seems Mohan does not understand the difference between a comment and an Answer.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Because the load is inductive, the current lags the voltage.(by a bit).
This is where this question deviates from being a 'generic' question, and becomes more specific.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
An Early Warning Sign of Dementia Risk May Be Keeping You Up at Night, Study Says - ScienceAlert
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
The other is “what does a “fuse” do?”
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Edit 2024–10.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
At least they know the answer if they wanted it.
nine
so, what happens?
It also is a device that limits the change in current flow.
[image of Common-mode choke]
This one hit behind the barn.
Here is a simplified AC power diagram.
a photo is worth a thousand words.
There are two important concepts here.
What does a fuse do?
A circuit breaker is similar, but is resettable.
He then describes the function of a fuse.
An AC voltage/ current source, and an ac inductive load.
I post the exact comment here.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
2024–10–14 [Omar Gharbi Omar Gharbi ]
One
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
The MOV will conduct when the voltage exceeds 50% of line voltage.
So, the voltage could go up to 500 volts, and the fuse will not open up.
But… the neutral is now “floating” because of the 1 ohm resistance.
but this device (an Inductor) … impedes the rapid changes in the current.
Now when you have a certain ac resistance, then a current flows in a loop.
But it can get overloaded, and no longer works.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
A fuse is a non-resetable over current circuit protector.
In schematic diagrams this is the symbol for a fuse:
what exactly is a ‘surge’ protector?
At one ohm, the resistor has a maximum of 1 watt power.
He then asserts :
2024–10–10[John johnson John Johnson ]
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
[old diagram got deleted by accident]
The bolt then partially travels down the line to your home.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
There are three different concepts here that are getting confused.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Can the fuse protect the electronic devices from lightning instead of a surge protector.
These devices are installed between the “hot” and “neutral” and protective ground.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This is 'the assistant's answer'
(Dc diagram shown, AC is similar).
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Barnstars:
What is lightning?
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
First Sentence: